-----------------------------------------------------------------
|             BOOTLEG Q*BERT WITH A MODERN JOYSTICK             |
-----------------------------------------------------------------

COPYRIGHT 2001

REVISION NUMBER: 1.0
  REVISION DATE: 09 March 2001
     CREATED BY: Mark Frisbie



STANDARD DISCLAIMER:
--------------------
REMEMBER, NO WARRANTEES, EXPRESS OR IMPLIED, ARE GIVEN.  USE THIS
INFORMATION AT YOUR OWN RISK.  I AM NOT RESPONSIBLE FOR ANY DAMAGES
THAT MAY OCCUR TO YOUR PERSON OR PROPERTY.


-----------------------------------------------------------



GENERAL OVERVIEW:
-----------------
The below modification will allow a Normally oriented Joystick
to function like the off-set Q*Bert Joystick. (this can be used
in a normal-verticle JAMMA cabinet with a JAMMA adaptor)




INGREDIENTS:
------------
1 -  Working Bootleg Q*Bert Board
1 -  74LS32 (14 pin Quad 2 Input OR gate)
1 -  Standard 4-position leaf switch or microswitch joystick
1 -  spool of jumper wire


INSTRUCTIONS:
-------------
First, jumper the 74LS32 as follows:
     Connect pin  1 to pin 12
     Connect pin  2 to pin 9
     Connect pin  4 to pin 10
     Connect pin  5 to pin 13
     Connect Pin  7 to GND
     Connect Pin 14 to +5V

Next, connect the 74LS32 to the bootleg Q*Bert board as follows:
     Connect Pin  3 to logic Up-Left
     Connect Pin  6 to logic Down-Right
     Connect Pin  8 to logic Down Left
     Connect Pin 11 to logic Up-Right

Finally, connect the 74LS32 to your "normal" joystick or JAMMA
harness as follows:
     Connect Pin  9 to JAMMA Left
     Connect Pin 10 to JAMMA Down
     Connect Pin 12 to JAMMA Up
     Connect Pin 13 to JAMMA Right




-----------------------------------------------------------------
|                              END                              |
-----------------------------------------------------------------