Gravitar Reproduction CPOs

The CPOs are available from Archer Maclean for £40 + £7 post to USA 4/5 day service, and additional options like signed-for etc. I know the £/$ rate is against me at the moment, but I have produced these in a very small run but very high quality, and I doubt I'll make a living out of it, so I'll keep my day job for now!

01 Does your Gravitar CPO look like this 2,480.13 Kb	02 not much left of it 338.17 Kb	03 Number the switches before removal to save time later 169.74 Kb	04 Stripped and shot blasted CP 182.13 Kb
05 CP with undercoat 186.96 Kb	06 now for nice new Grav CPO 203.83 Kb	06a CPO close up 1 182.71 Kb	07 carefully expose a bit of adhesive around buttons 85.36 Kb
08 stand CP and CPO on common edge and lightly press middle strip to CP 270.84 Kb	09 CPO peeled back to show strip of adhesive 177.24 Kb	10 use horizontal desk light to check holes line up 142.29 Kb	11 smoothed out CPO showing top edge overlap before trimming 178.72 Kb
12 now trim top edge with sharp blade angled INTO CPO 278.81 Kb	13 CPO top edge after trimming shows white up 292.29 Kb	14 Now run black sharpie along CPO edge AWAY from image side to avoid mishaps 212.83 Kb	15 buttons and loom ready 222.88 Kb
16 Using scalple blade cut out buttons holes according to your specific CP 235.53 Kb	17 Buttons and holes have small alignment notches 178.55 Kb	18 The final result 1 220.29 Kb

go here to see more of Archer's work