1000 Miglia (Great 1000 Miles Rally) KANEKO 1994, Inc. Pinouts = JAMMA ------------------------------------------------------------------------ + 5V (+0.5 -0.1) -> 4A +12V (+0.5 -0.5) -> 1A DIP Switch on Rom Board | SW1 | SW2 | SW3 | SW4 | SW5 | SW6 | SW7 | SW8 | --------------------------|-----|-----|-----|-----|-----|-----|-----|-----| Normal Mode | OFF | | | | | | | | Settings Mode | ON | | | | | | | | --------------------------------------------------------------------------| Normal Screen | | OFF | | | | | | | Reverse Screen | | ON | | | | | | | --------------------------|-----|-----|-----|-----|-----|-----|-----|-----| Upright | | | OFF | | | | | | Table | | | ON | | | | | | --------------------------|-----|-----|-----|-----|-----|-----|-----|-----| Controllers **| | | | OFF | | | | | | | | | ON | | | | | --------------------------|-----|-----|-----|-----|-----|-----|-----|-----| Controller: 1P side | | | | | OFF | | | | Controller: both side | | | | | ON | | | | --------------------------|-----|-----|-----|-----|-----|-----|-----|-----| A button = Brake *| | | | | | OFF | | | Brake unused | | | | | | ON | | | --------------------------|-----|-----|-----|-----|-----|-----|-----|-----| Anthem&Flag: | | | | | | | | | Follow memory settings | | | | | | | OFF | OFF | National Anthem, no flag | | | | | | | ON | OFF | National Flag, no anthem | | | | | | | OFF | ON | Neither used | | | | | | | ON | ON | --------------------------|-----|-----|-----|-----|-----|-----|-----|-----| *: this setting is valid only when the joystick is used. When Dip Switch 6 is turned on, Brake Button is not used. Button A turns to be Accelerator Button. **: Controllers | Dip on Rom Board | Dip on Daughter Board | NH connectors used | ----------------------|------------------|-----------------------|--------------------| Joystick | 4:OFF | | | ----------------------|------------------|-----------------------|--------------------| 360o Wheel | 4:ON ; 5:OFF | 1:ON | 6 pins ; #3-#6 | ----------------------|------------------|-----------------------|--------------------| 270o Wheel | 4:ON ; 5:ON | 2:ON | 5 pins ; #1-#3 | ----------------------|------------------|-----------------------|--------------------| NH connectors on pcb | Pin at Wheel | ---------------------|--------------| pin #3 | +5V | ---------------------|--------------| pin #4 | Clock *** | ---------------------|--------------| pin #5 | Up-Down | ---------------------|--------------| pin #6 | Ground | ---------------------|--------------| ***: Clock pulse width = minimum 2ms. When Clock goes high from low: - and up-down pulse is high -> Clockwise - and up-down pulse is low -> CCW