Pacman Video Circuitry Theory of Operations (c) Mark Spaeth 1999 After searching the net for info while fixing a stack of dead pacman boards, I couldn't find any documentation on the video circuitry. This document is an attempt to rectify the problem. Since pacman uses a rotated monitor, the term horizontal will refer to things that appear on the vertical axis and vice-versa, so that the description will match the labeling on the schematics (not just to confuse you). Sync and Timing Signal Generation --------------------------------- The count sequences for the horizontal and vertical timing signals are listed at the end. The horizontal timing and sync signals are generated from the 6Mhz clock using the chips at 2P, 3R, 3S, and 8C. The system-wide 6Mhz timing signal clocks the 7474 flipflop at 8C to generate the 3Mhz 1H signal, which controls the timing of each horizontal pixel. The 74161 counter at 3R is enabled by 1H and generates the 2H, 4H, 8H, and 16H signals each at half the frequency of the previous signal. The carryout of of 3R is asserted when all 4 counter bits are one, and enables the counter at 3S which generates 32H, 64H, 128H, and /256H. The NOR at 2P inverts the carrout of 3S which is used as the load signal for 3R and 3S that modifies the count sequence. Instead of rolling the counters (including /256H down to 1H) back to 000000000 after 111111111, the load sets the count to 010000001 after 111111110, yielding a 382-count period for the horizontal circuitry. Note that 3Mhz / 382 gives an approximate 16kHz period. The horizontal blanking signals are generated in 2P, 3N, and 3P. The NOR at 2P inverts the /256H signal and uses it as the (active low) clear signal for the flipflop at 3N (ie. when /256H is one, the output of the flipflop is always zero). The flipflip is set to one when 16H goes high for the first time after the count rolls back to 010000001. It is cleared again on the rising edge of 16H when 32H and 64H are both high. This yields a 96-count blanking interval, and a 286-count data interval (so the actual resolution is 286 pixels, not 288 as most documentation says). The /HSYNC signal is generated at 3N. HBLANK presets the second flipflip at 3N, forcing /HSYNC high outside of the blanking period. The output is cleared the first time 16H goes high after the start of the blanking period and is cleared on the rising edge of 16H when 64H is high, generating a 32-count sync period. The vertical timing signals are generated from the HSYNC signal using the chips at 2P, 2R, 2S, and 5M. The 7474 at 5M is clocked by HSYNC to generated the 1V signal. 2V, 4V, 8V, and 16V are generated by the 74161 at 2R that is enabled by 1V. 32V, 64V, 128V, and ~VSYNC are generated by the 74161 at 2S that is enabled by the carryout of 2R. The carryout of 2S is inverted by the NOR at 2P, and is used as the load signal for 2R and 2S. This makes the count (including 1V) to roll from 111111110 to 011111001, yielding a 262-count period. The ~VSYNC signals is low for 7 counts at the beginning of the count sequence. VBLANK is generated by a flipflop at 5M. VBLANK is cleared when 16V goes high when 32V, 64V, and 128V, near the end of the count sequence. It is reset when 16H goes high when 32V, 64V, and 128V are all low near the beginning of the count sequence. The vertical blanking period lasts for 38 HSYNC cycles leaving 224 counts for data (thus the 224 line vertical resolution). Memory Map --------- Sure there's more to it, but this is all the video system cares about. 0000-3fff ROM 4000-43ff Video Ram (screen background character codes) 4400-47ff Color Ram (screen background color codes) 4c00-4cef Scratch Ram 4cf0-4cff Sprite Ram Byte 0: Sprite Code <7:2>, X Flip <1>, Y Flip <0> Byte 1: Color Code Sync Bus Controller ------------------- The sync bus controller interfaces the external devices to the processor. The address and data bus are connected to the roms directly, but for ram and IO port access the sync bus controller gets in the way. An important thing to note is that the 6M* input to the SBC trails the 6Mhz used to generate the timing clocks by 1/3 phase, so the edge occurs during each level of 1H. The /CS line is asserted during a /MREQ with A14 high, during a non-refresh cycle (/RFSH high). To handle interrupts, Pacman uses the I interrupt regiester to store the high 8 bits of the interrupt vector address and writes the low 8 bits to 0x00, which stores it in the register at U7. During a mode 0 interrupt, /IORQ and /M1 are asserted, and the stored value is put back onto the data bus, and used as the low 8 bits of the of interrupt vector. VRAM Addresser -------------- The VRAM addresser determines the address to be accessed by the video output circuitry based on the values of the horizontal and vertical timing signals. The address is enabled by /2H. When 2H is low, the CPU controls the bus. When 2H is high, the video generator controls it. When /256H is high, normal screen data is being output. The low 10 bits of the VRAM address are determined by [128V, 64V, 32V, 16V, 8V, 128H, 64H, 32H, 16H, 8H]. The high bit is always 0, and the 11th bit is 4H, so that background sprite numbers are read on one cycle (4N), and the color is read the next (4P). 4V, 2V, 1V, 4H, 2H, and 1H are not used in the address directly, since they are not needed, since the sprites are 8x8 pixels. The data addressed here is When /256H is low, the outputs are determined by whether 16H==32H==64H. If all three are euap, the address is [0, 4H, 64H, 64H, 64H, 64H, 8H, 128V, 64V, 32V, 16V, 8V]. This occurs when drawing either the score area or level area. The address is scrambled to use the screen ram area that is not used by the screen itself. During VBLANK, the VRA addresses 4FF2-4FFD, where the motion object sprite numbers and color codes are stored. Note that due to the addressing, only 6 of the 8 sprite positions can be used. 4004-403B : Score area 4040-43BF : Screen area 43C4-43FB : Level area Horizontal Timing Signals ------------------------- ~ (382 lines, 96 blanked, 286 data) 21 ~~ 52631 HHH 684268421 BBS ------------ 010000001 011 010000010 011 010000011 011 010000100 011 010000101 011 010000110 011 010000111 011 010001--- 011 010010--- 101 010011--- 101 010100--- 101 010101--- 101 010110--- 100 010111--- 100 011000--- 100 011001--- 100 011010--- 101 011011--- 101 011100--- 101 011101--- 101 011110--- 011 011111--- 011 100000--- 011 100001--- 011 100010--- 011 100011--- 011 100100--- 011 100101--- 011 100110--- 011 100111--- 011 101000--- 011 101001--- 011 101010--- 011 101011--- 011 101100--- 011 101101--- 011 101110--- 011 101111--- 011 100000--- 011 100001--- 011 100010--- 011 100011--- 011 100100--- 011 100101--- 011 100110--- 011 101111--- 011 111000--- 011 111001--- 011 111010--- 011 111011--- 011 111100--- 011 111101--- 011 111110--- 011 111111000 011 111111001 011 111111010 011 111111011 011 111111100 011 111111101 011 111111110 011 Vertical Timing Signals ----------------------- ~1 ~ (262 rows, 38 blanked, 224 normal) V2631 V S84268421 B ----------- 011111001 0 011111010 0 011111011 0 011111100 0 011111101 0 011111110 0 011111111 0 100000--- 0 100001--- 0 100010--- 1 0000 0100 00000 100011--- 1 100100--- 1 100101--- 1 100110--- 1 100111--- 1 101000--- 1 101001--- 1 101010--- 1 101011--- 1 101100--- 1 101101--- 1 101110--- 1 101111--- 1 110000--- 1 110001--- 1 110010--- 1 110011--- 1 110100--- 1 110101--- 1 110110--- 1 110111--- 1 111000--- 1 111001--- 1 111010--- 1 111011--- 1 111100--- 1 111101--- 1 0011 1011 1111 111110--- 0 111111000 0 111111001 0 111111010 0 111111011 0 111111100 0 111111101 0 111111110 0 Sprites: 4ff0-4fff 8 pairs of two bytes: Byte 1: sprite image number (bits 2-7), Y flip (bit 0), X flip (bit 1); Byte 2: the color # 0100 1111 1111 x x x x ^ ^ ^ ^ H64 H32 H16 H4 (?) Addressed from VRA during: ~256H = 0 (74257 select input) 16H != 32H or 32H != 64H (74157 select input)