--------------------------------
Commodore Amiga 1942 pinouts:
--------------------------------

 Pin 1: Red
 Pin 2: Green
 Pin 3: Blue
 Pin 4: Unused
 Pin 5: Unused
 Pin 6: Red Ground
 Pin 7: Green Ground
 Pin 8: Blue Ground
 Pin 9: Unused
Pin 10: Digital Ground
Pin 11: Digital Ground
Pin 12: Unused
Pin 13: Horizontal Sync
Pin 14: Vertical Sync
Pin 15: Unused


Hi all

Thank you VERY much for all the help. I did not give you enough info on the
first post though. I  have a Commodore Amiga 1942 monitor which has the
pinouts found on the bottom of this message (found them on the great
Amiga-Hardware page on http://www.amiga-hardware.com/1940.html). The various
1084 models are covered on http://www.amiga-hardware.com/1084.html).

As you also can read on the 1942 page mentioned above, the input connector
is a permanent HDD15 (looks much like a standard PC VGA connectors).

I do not want to cut the orginal monitorcable on my monitor (integrated as
it is). Any hints on a good method of getting this stuff together? If I
bought an extensioncable for the monitorcable and cut that  - then soldered
it to JAMMA-connector ..... would that work?

Am I (as often ;-) missing something obviously easy here, and want to go
trough more monitortrouble than I have too? :-) Any other methods to hook it
up?

Hope to hear your suggestions.