ZANEN ELECTRONICS
5023 52nd Street
Lubbock, Texas 79414

806-793-6337 Fax: 806-793-9136
                                                            
Kit # 101 Installation Instructions
                                                           
This monitor repair kit is designed for the Electrohome G07-CBO 19
inch color monitor.

Be sure to check that all the parts are included in the kit:
1 1 uF @ 50V or 63V         1 2200 uF @ 25V
1 4.7 uF 0 50V              1 1 uF @ 250V
1 4.7 uF @63Vor 100V        1 3.3 uF @ 160V
1 10 uF @50V                2 10 uF 0 250V
1 33 uF @25V                1 47 uF @ 200V
3 100 uF @ 16V              1 100 uF @ 160V
2 220 uF @ 16V                                      
             
Be sure to install all the parts on the monitor even though many of
the original
parts seem to be working fine. Age, humidity, and temperature will
cause the value of electrolytic capacitors to change. Installing all
of the parts will assure many more years of trouble free service. Each
capacitor is polarized and can only be inserted in one direction.
Watch the polarity markings on each capacitor. On the top side of the
monitoriaard where each capacitor is located is a circle with a black
dot on. one side. The black dot indicates where the negative (-) lead
is to be inserted.

Remove the shield over IC501 and install the following parts.
C302 220 uF @ 16V           C511' 47 uF @ 200V
C403 100 uF @ 16V           C517 100 uF @ 16V
C407 4.7 uF @ 63V or 100V   C518 220 uF @ 16V
C408 4.7 uF @ 50V           C521 2200 uF @ 25V
C411 100 uF @ 160V          C523 1 uF 0 250V
C412 3.3 uF @ 160V          C701 100 uF @ 16V
C504 1 uF @  50V or 63V     C905 10 uF @ 250V
C506 33 uF @ 25V            C107 10 uF @ 250V - Neck Board

IMPORTANT! Be sure to install the negative lead of C302 into the hole
with the black dot shown on the top side of the chassis. The (+) sign
on the bottom side of C302 is marked incorrectly. The last step is to
install a sync modification which prevents a horizontal curl. This
step is optional. On the monitor board, replace C303 with the 10uF 0
50V capacitor with the positive lead connected to the collector of
X305. Then replace C501 with the capacitor taken from space C303. If
you have any problems call us for help.

(C) 1989 Zanen Electronics. All Rights Reserved  
===============================================================================