Stargate control panel layout and measurements - typed by Franklin Bowen (bowens@erols.com) 4/8/96 ================================================================================ Here's the layout (courtesy of Steve Hawley - hawley@adobe.com) (1) (2) O (T)(F) (R) (S) (H) (I) 1,2 - 1 and 2 player start, tranparent red O - up,down lever, red (can use a Joust stick) R reverse, white T thrust, white F fire, white S smart bomb, green I inviso, red H hyperspace, white FYI, the defender layout was identical except that the 1 & 2 player start buttons were white and there was no inviso. The wiring harness for stargate will work on a Defender board set. ================================================================================ ================================================================================ All measurements are in cm - plywood is 1.9 thick 17.1 *---------- |A 14.7 ^ | | 14.7 | 11.6 17.2 (from side) | | |B 7.35 v *------ 9.05 * is rounded and around 2.1 cm thick - Angle A is 99 o while angle B is 101 o. ================================================================================ (looking down on top of control panel) <- 62 -> *----------------------------------------------------------------------------* | | | 2.5 | | - 4.7 4.7 4.7 4.7 | | | | 27.15 O O 27.15 O O 11.75 | | | | <- 15.5 -> | |12.9|O| 7.65 | | | | O 18.4 | | | | 9.7 | | - O 10.65 | |<- 18.5 -> O 21.25 | | 29.45 O 29.45 | | 4.7 | *----------------------------------------------------------------------------* - Os are buttons and joystick - measurements are from CENTER of button hole THROUGH the number - measurements are from the EDGE of the joystick THROUGH the number - the measurements from the bottom would be if it was UNROUNDED! - rounding starts 15.4cm from top - button holes are 2.95-3cm across - channel for joy is 2.45cm wide and ABOUT 6.7-7cm long